Papito
1457 18Th Street
P
Last inspected: March 13, 2025
Inspection History
March 13, 2025
Foodborne Illness
Pass
P
114002Rapidly cool potentially hazardous foods from 135°F to 70°F within 2 hours, then from 70°F to 41°F within 4 hours. Discontinue cooling PHF's at room temperature. Rapid cool by any of the following approved methods: 1) Ice water bath 2) Ice wand 3) Shallow stainless steel pans filled 2-3 inches and store in refrigerator 4) Separate into smaller or thinner portions and store in refrigerator 5) Blast chiller 6) Any combination of the above. Use the following approved methods provided on the rapid cooling guideline., 113996, 113998, 114037, 114429, 114429.3, 114429.5 - Keep potentially hazardous foods (PHF) cold at 41°F or below or hot held at 135°F or above. Immediately discontinue storing PHF at room temperature., 114074, 114081, 114119, 114121, 114161, 114178, 114179, 114083, 114185, 114185.2, 114185.3, 114185.4, 114185.5 - All clean and soiled linen shall be properly stored; non-food items shall be stored and displayed separate from food and food-contact surfaces. Utensils and equipment shall be handled and stored so as to be protected from contamination., 114115 (b,c) - Maintain nonfood contact surfaces clean. Thoroughly clean and degrease the cooking equipment and shelves above cooking equipment., 113953, 113953.1, 113953.2, 114067(f) - Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times., 114016 - Reheat all potentially hazardous food to minimum internal temperature of 165°F or above within 2 hours prior to hot holding. Do not use hot holding equipment to reheat potentially hazardous foods., 114143(d), 114266, 114268, 114268.1, 114271, 114272 - Provide walls / ceilings using materials that are durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable, and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair.
114002.1Rapidly cool potentially hazardous foods from 135°F to 70°F within 2 hours, then from 70°F to 41°F within 4 hours. Discontinue cooling PHF's at room temperature. Rapid cool by any of the following approved methods: 1) Ice water bath 2) Ice wand 3) Shallow stainless steel pans filled 2-3 inches and store in refrigerator 4) Separate into smaller or thinner portions and store in refrigerator 5) Blast chiller 6) Any combination of the above. Use the following approved methods provided on the rapid cooling guideline., 113996, 113998, 114037, 114429, 114429.3, 114429.5 - Keep potentially hazardous foods (PHF) cold at 41°F or below or hot held at 135°F or above. Immediately discontinue storing PHF at room temperature., 114074, 114081, 114119, 114121, 114161, 114178, 114179, 114083, 114185, 114185.2, 114185.3, 114185.4, 114185.5 - All clean and soiled linen shall be properly stored; non-food items shall be stored and displayed separate from food and food-contact surfaces. Utensils and equipment shall be handled and stored so as to be protected from contamination., 114115 (b,c) - Maintain nonfood contact surfaces clean. Thoroughly clean and degrease the cooking equipment and shelves above cooking equipment., 113953, 113953.1, 113953.2, 114067(f) - Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times., 114016 - Reheat all potentially hazardous food to minimum internal temperature of 165°F or above within 2 hours prior to hot holding. Do not use hot holding equipment to reheat potentially hazardous foods., 114143(d), 114266, 114268, 114268.1, 114271, 114272 - Provide walls / ceilings using materials that are durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable, and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair.
September 26, 2024
Routine
Pass
P
1114149-114149.3Provide exhaust hoods to remove toxic gases, heat, grease, vapors, and smoke and be approved by the local building department. Canopy-type hoods shall extend 6 inches beyond all cooking equipment. Toilet rooms shall be vented to the outside air by a screened openable window, an air shaft, or a light-switch activated exhaust fan, consistent with local building codes. Adequate lighting shall be provided in all areas to facilitate cleaning and inspection. Light fixtures in areas where open food is stored, served, prepared, and where utensils are washed shall be of shatterproof construction or protected with light shields., 114115 (b,c) - Maintain nonfood contact surfaces clean. Thoroughly clean and degrease the cooking equipment and shelves above cooking equipment., 113953, 113953.1, 113953.2, 114067(f) - Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times., 114259, 114259.1, 114259.4, 114259.5 - Eliminate the infestation/activity of cockroaches/rodents/flies/vermin from the food facility by using only approved methods. Remove all evidence of the infestation and thoroughly clean and sanitize all affected surfaces. Construct, equip, maintain and operate the food facility so as to prevent the entrance and harborage of animals, birds and vermin including, but not limited to, rodents and insects., 114143(d), 114266, 114268, 114268.1, 114271, 114272 - Provide walls / ceilings using materials that are durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable, and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair.
114252Provide exhaust hoods to remove toxic gases, heat, grease, vapors, and smoke and be approved by the local building department. Canopy-type hoods shall extend 6 inches beyond all cooking equipment. Toilet rooms shall be vented to the outside air by a screened openable window, an air shaft, or a light-switch activated exhaust fan, consistent with local building codes. Adequate lighting shall be provided in all areas to facilitate cleaning and inspection. Light fixtures in areas where open food is stored, served, prepared, and where utensils are washed shall be of shatterproof construction or protected with light shields., 114115 (b,c) - Maintain nonfood contact surfaces clean. Thoroughly clean and degrease the cooking equipment and shelves above cooking equipment., 113953, 113953.1, 113953.2, 114067(f) - Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times., 114259, 114259.1, 114259.4, 114259.5 - Eliminate the infestation/activity of cockroaches/rodents/flies/vermin from the food facility by using only approved methods. Remove all evidence of the infestation and thoroughly clean and sanitize all affected surfaces. Construct, equip, maintain and operate the food facility so as to prevent the entrance and harborage of animals, birds and vermin including, but not limited to, rodents and insects., 114143(d), 114266, 114268, 114268.1, 114271, 114272 - Provide walls / ceilings using materials that are durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable, and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair.
114252.1Provide exhaust hoods to remove toxic gases, heat, grease, vapors, and smoke and be approved by the local building department. Canopy-type hoods shall extend 6 inches beyond all cooking equipment. Toilet rooms shall be vented to the outside air by a screened openable window, an air shaft, or a light-switch activated exhaust fan, consistent with local building codes. Adequate lighting shall be provided in all areas to facilitate cleaning and inspection. Light fixtures in areas where open food is stored, served, prepared, and where utensils are washed shall be of shatterproof construction or protected with light shields., 114115 (b,c) - Maintain nonfood contact surfaces clean. Thoroughly clean and degrease the cooking equipment and shelves above cooking equipment., 113953, 113953.1, 113953.2, 114067(f) - Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times., 114259, 114259.1, 114259.4, 114259.5 - Eliminate the infestation/activity of cockroaches/rodents/flies/vermin from the food facility by using only approved methods. Remove all evidence of the infestation and thoroughly clean and sanitize all affected surfaces. Construct, equip, maintain and operate the food facility so as to prevent the entrance and harborage of animals, birds and vermin including, but not limited to, rodents and insects., 114143(d), 114266, 114268, 114268.1, 114271, 114272 - Provide walls / ceilings using materials that are durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable, and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair.
April 11, 2024
Routine
Pass
P
114002Rapidly cool potentially hazardous foods from 135°F to 70°F within 2 hours, then from 70°F to 41°F within 4 hours. Discontinue cooling PHF's at room temperature. Rapid cool by any of the following approved methods: 1) Ice water bath 2) Ice wand 3) Shallow stainless steel pans filled 2-3 inches and store in refrigerator 4) Separate into smaller or thinner portions and store in refrigerator 5) Blast chiller 6) Any combination of the above. Use the following approved methods provided on the rapid cooling guideline., 113984(d), 114097, 114099.1, 114099.4, 114099.6, 114101(b, c, d), 114105, 114109, 114111, 114113, 11415 (a, b, D), 114117, 114125(b), 114141 - Properly wash, rinse and sanitize all food contact surfaces. Make a 100 ppm bleach sanitizing solution or a 200 ppm quaternary ammonia solution for the third compartment., 113952, 113953.3, 113953.4, 113961, 113973 - Properly wash hands with hand soap and warm water for a minimum of 10 seconds at the hand washing station when beginning work; before handling food/equipment/utensils; as often as necessary during food preparation to remove soil and contamination; switching from working with raw to ready-to-eat foods; after touching body parts; after using toilet room; contamination of hands occurs. Food employees shall minimize contact with exposed, ready-to-eat food with their bare hands and shall use suitable utensils, gloves, or dispensing equipment., 113953, 113953.1, 113953.2, 114067(f) - Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times.
114002.1Rapidly cool potentially hazardous foods from 135°F to 70°F within 2 hours, then from 70°F to 41°F within 4 hours. Discontinue cooling PHF's at room temperature. Rapid cool by any of the following approved methods: 1) Ice water bath 2) Ice wand 3) Shallow stainless steel pans filled 2-3 inches and store in refrigerator 4) Separate into smaller or thinner portions and store in refrigerator 5) Blast chiller 6) Any combination of the above. Use the following approved methods provided on the rapid cooling guideline., 113984(d), 114097, 114099.1, 114099.4, 114099.6, 114101(b, c, d), 114105, 114109, 114111, 114113, 11415 (a, b, D), 114117, 114125(b), 114141 - Properly wash, rinse and sanitize all food contact surfaces. Make a 100 ppm bleach sanitizing solution or a 200 ppm quaternary ammonia solution for the third compartment., 113952, 113953.3, 113953.4, 113961, 113973 - Properly wash hands with hand soap and warm water for a minimum of 10 seconds at the hand washing station when beginning work; before handling food/equipment/utensils; as often as necessary during food preparation to remove soil and contamination; switching from working with raw to ready-to-eat foods; after touching body parts; after using toilet room; contamination of hands occurs. Food employees shall minimize contact with exposed, ready-to-eat food with their bare hands and shall use suitable utensils, gloves, or dispensing equipment., 113953, 113953.1, 113953.2, 114067(f) - Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times.