Plan Check Team
49 S Van Ness Ave 7Th Floor
P
Last inspected: July 19, 2024
Inspection History
July 19, 2024
Pass
P
114244Provide a floor plan showing the path-of-travel to the refuse storage area., 114271 - Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 113953, 113953(b) - Provide minimum 6 inches high side splashguard(s) with rounded corners., 114193, 114193.1, 114269 - Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel., 114268 - The floor finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 114259.2 - Passthrough window service openings shall be limited to 216 square inches each. The service openings shall not be closer together than 18 inches. Each opening shall be provided with a solid or screened window, equipped with a self-closing device. Screening shall be at least 16 mesh per square inch. Passthrough windows of up to 432 square inches are approved if equipped with an air curtain device. The counter surface of the service openings shall be smooth and easily cleanable., 114047, 114153 - Adequate and suitable space shall be provided for the storage of food, on approved shelving with a minimum of 6 inch clearance from the floor., 114266, 114257, 114257.1, 114259 - Each permanent food facility shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure., 114244, 114245 - Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils., 114268 - Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches., 114271(d) - Conduits of all types shall be installed within walls as practicable. When otherwise installed, they shall be mounted or enclosed so as to facilitate cleaning., 114256 - Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur., 114163 - All permanent food facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a food preparation sink with a single integral drainboard. The food preparation sink shall have a minimum dimension of 18"x18"x12" (LxWxD) with an integral drainboard at least 18"x18" (LxW)., 114279, 114281, 114282 - After use, mops shall be placed in a position that allows them to air-day without soiling walls, equipment, or supplies, e.g. wall-mounted mop rack., 114099 - Sink compartments shall be large enough to accommodate the immersion of the largest equipment and utensils.
114245Provide a floor plan showing the path-of-travel to the refuse storage area., 114271 - Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 113953, 113953(b) - Provide minimum 6 inches high side splashguard(s) with rounded corners., 114193, 114193.1, 114269 - Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel., 114268 - The floor finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 114259.2 - Passthrough window service openings shall be limited to 216 square inches each. The service openings shall not be closer together than 18 inches. Each opening shall be provided with a solid or screened window, equipped with a self-closing device. Screening shall be at least 16 mesh per square inch. Passthrough windows of up to 432 square inches are approved if equipped with an air curtain device. The counter surface of the service openings shall be smooth and easily cleanable., 114047, 114153 - Adequate and suitable space shall be provided for the storage of food, on approved shelving with a minimum of 6 inch clearance from the floor., 114266, 114257, 114257.1, 114259 - Each permanent food facility shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure., 114244, 114245 - Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils., 114268 - Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches., 114271(d) - Conduits of all types shall be installed within walls as practicable. When otherwise installed, they shall be mounted or enclosed so as to facilitate cleaning., 114256 - Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur., 114163 - All permanent food facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a food preparation sink with a single integral drainboard. The food preparation sink shall have a minimum dimension of 18"x18"x12" (LxWxD) with an integral drainboard at least 18"x18" (LxW)., 114279, 114281, 114282 - After use, mops shall be placed in a position that allows them to air-day without soiling walls, equipment, or supplies, e.g. wall-mounted mop rack., 114099 - Sink compartments shall be large enough to accommodate the immersion of the largest equipment and utensils.
July 19, 2024
Pass
P
114244Provide a floor plan showing the path-of-travel to the refuse storage area., 114271 - Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 113953, 113953(b) - Provide minimum 6 inches high side splashguard(s) with rounded corners., 114193, 114193.1, 114269 - Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel., 114268 - The floor finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 114259.2 - Passthrough window service openings shall be limited to 216 square inches each. The service openings shall not be closer together than 18 inches. Each opening shall be provided with a solid or screened window, equipped with a self-closing device. Screening shall be at least 16 mesh per square inch. Passthrough windows of up to 432 square inches are approved if equipped with an air curtain device. The counter surface of the service openings shall be smooth and easily cleanable., 114047, 114153 - Adequate and suitable space shall be provided for the storage of food, on approved shelving with a minimum of 6 inch clearance from the floor., 114266, 114257, 114257.1, 114259 - Each permanent food facility shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure., 114244, 114245 - Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils., 114268 - Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches., 114271(d) - Conduits of all types shall be installed within walls as practicable. When otherwise installed, they shall be mounted or enclosed so as to facilitate cleaning., 114256 - Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur., 114163 - All permanent food facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a food preparation sink with a single integral drainboard. The food preparation sink shall have a minimum dimension of 18"x18"x12" (LxWxD) with an integral drainboard at least 18"x18" (LxW)., 114279, 114281, 114282 - After use, mops shall be placed in a position that allows them to air-day without soiling walls, equipment, or supplies, e.g. wall-mounted mop rack., 114099 - Sink compartments shall be large enough to accommodate the immersion of the largest equipment and utensils.
114245Provide a floor plan showing the path-of-travel to the refuse storage area., 114271 - Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 113953, 113953(b) - Provide minimum 6 inches high side splashguard(s) with rounded corners., 114193, 114193.1, 114269 - Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel., 114268 - The floor finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms., 114259.2 - Passthrough window service openings shall be limited to 216 square inches each. The service openings shall not be closer together than 18 inches. Each opening shall be provided with a solid or screened window, equipped with a self-closing device. Screening shall be at least 16 mesh per square inch. Passthrough windows of up to 432 square inches are approved if equipped with an air curtain device. The counter surface of the service openings shall be smooth and easily cleanable., 114047, 114153 - Adequate and suitable space shall be provided for the storage of food, on approved shelving with a minimum of 6 inch clearance from the floor., 114266, 114257, 114257.1, 114259 - Each permanent food facility shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure., 114244, 114245 - Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils., 114268 - Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches., 114271(d) - Conduits of all types shall be installed within walls as practicable. When otherwise installed, they shall be mounted or enclosed so as to facilitate cleaning., 114256 - Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur., 114163 - All permanent food facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a food preparation sink with a single integral drainboard. The food preparation sink shall have a minimum dimension of 18"x18"x12" (LxWxD) with an integral drainboard at least 18"x18" (LxW)., 114279, 114281, 114282 - After use, mops shall be placed in a position that allows them to air-day without soiling walls, equipment, or supplies, e.g. wall-mounted mop rack., 114099 - Sink compartments shall be large enough to accommodate the immersion of the largest equipment and utensils.